CURING COMPOUND MOULD - ASTM C156-03

Compliance with ASTM C156 - 03/ ASTM C309.

Construction details :

1. The mould is made of stainless steel material and it is water tight as per the standard requirement.
2. The mould is rigidly constructed to prevent distortion and it is thoroughly cleaned.
3. The interior faces of the mould are plane surface.
4. The mould is measured as 150mm x 300mm at the top, 143 x 295 mm at bottom, and 50 mm deep on the inside surface.
5. The mould is flat rim at the top on all sides approximately 6mm in width.

Note :

Poking rod and wooden float will be supplied at extra cost.  Other essential Instruments Viz. Reflectance meter, Humidity chamber, Mortar Mixer, Electronic weighing Balance available.