FLOW TABLE (CONCRETE)-700 X 700 MM-IS 9103, EN 12350-5

Compliance Standards:

IS 9103, EN 12350-5, IS:1199-Part 2

Details:

Flow table top will be Constructed from a flat metal plate of minimum thickness 1.5mm. The top will have a plan area of 700mm x 700mm and a flatness of within 1.5mm. The center of the table will be scribed with a cross, the lines of which run parallel to and out to the edges of the plate and with a central circle 200mm in diameter. The under surface of the plate will be reinforced in order to prevent distortion of the flat surface. The front of the flow table top will be provided with a lifting handle as shown in Fig .1 of IS 1903. The total mass of the flow table top will be 16 kg.

The flow table top will be hinged to a base frame using externally mounted hinges in such a way that no aggregate can become trapped easily between the hinges or hinged surfaces. The front of the base frame will extend a minimum 120mm beyond the flow table top in order to provide a top board, An upper stop similar to that shown in Fig. 1A will be provided on each side of the table so that the lower front edge or the table can only be lifted 40 ± 1mm

The lower front edge of the flow table top will be provided with two hard rigid stops which transfer the load of the base frame. The base frame will be so constructed that this load is then transferred directly constructed that this load is then transferred directly to the surface, on which the flow table, is placed so that there is minimal tendance for the flow table top to bounce when allowed to fall.

Accessory Apparatus:

1. The mould will be made of a metal readily not attached by cement paste or liable to rust and of minimum thickness 1.5mm thick. The interior of the mould will be smooth and free from projections such as protruding rivets. and will be free from dents. The mould will be in the from of a hollow frustrum of a cone having the internal dimensions as shown in Fig 2 of BIS 1903. The cone has a 130 ±2 mm top diameter, 200 ±2 mm base diameter and 200 ±2 mm height and 1.5 mm thickness. The base and the top shall be open and parallel to each other and at right angles to the axis of the cone. The Tamping Bar will be made of Hardwood and having a 40mm x 40mm section of length 200mm, with a circular section to form a handle to the bar.

Essential Accessories at extra cost :

1. Masonary Trowel- 6”
2. Sop watch- Digital
3. S.S. Scale 1 mtr.