SOXHLET EXTRACTION HEATER- MANTLE TYPE-250 ML X 3 FLASKS

Model Number : EIE-213EP3MA

None

This apparatus is suitable to heat soxhlet flasks. The heating element is attached to fiber glass yarn-knitted fabric to provide flexible support to bottom of the flask. Glass wool insulation is used below the elements in the housing which is phosphated and powder coated attractively. In the event of spillage the solvent will either evaporate or escape through the drainage hole below each element. The housing has two retort rods and a cross bar on which the extraction apparatus has a built-in regulator which controls the heaters. The heating elements have individual on/off switches and a pilot lamp to indicate working of the elements. The apparatus requires a 230 Volts AC single phase supply. Supplied Without glass parts, Bosshead, Rubber tube coil and Finger clamps. These are essential accessories to operate the Instrument and should be purchased as per the flask holding capacity of the apparatus.

Suitable to heat Soxhlet Flasks
Type of Soxhlet	Unit with 3 Mantle Type heaters
Insulation	Glass wool insulation below the heating elements to prevent thermal loss
Heating element	Attached to fiber glass yarn knitted fabric to provide flexible support to the Flask bottom
Housing	Phosphated and Powder coated in attractive shades
Housing comprises	Two retort rods and a cross bar, on which the extraction apparatus rests.
Temp Controller	Built in regulators for individual heaters, which controls the heaters
Control panel	Individual on/off switches and Pilot lamps to indicate working of the elements
Drainage hole	In the event of spillage, the solvent will either evaporate or escape through this hole
Suitable for	250 ml capacity Flasks
Operation on	230 Volts, AC, single phase, supply
Supplied without	Clamps and Bosshead for flasks.
Supplied without	Glass parts (Flasks, Extractors and condensers have to be ordered at extra cost)
Optional Accessories	Complete glass assembly consisting of Flask, Extractor and Allihn Condenser unit @Rs.2450
Note	Above glass assembly pricing is per set. Customer needs to place order for 3 glass parts assembly for 3 mantle heaters.