NABL Accredited Calibration Laboratory
COMPRESSION TESTING MACHINE - 1200 KN-ANALOG - SINGLE GAUGE

COMPRESSION TESTING MACHINE - 1200 KN-ANALOG - SINGLE GAUGE

Model Number : TM-042A.1200.1

Compliance with following international standards - IS 516, IS 14858. Detailed specification as follows: Note: We strongly recommend using a servo voltage stabilizer to protect the Compression Testing Machine from overvoltage. The machine incorporates sensitive electronic components. Operating it without a stabilizer may cause serious damage or breakdown, which will not be covered under warranty.”

NUMBER OF GAUGE

Salient Features:

  1. Aesthetically designed unit
  2. The electric pumping unit is fixed with a micro? Switch to switch off the motor automatically as the load on the machine approaches the rated capacity.
  3. The unit is equipped with a 8" dia pressure gauges with maximum red pointer.
  4. Four column high stiffness and high stability fully welded construction of the load frame.

Construction Details :

The compression testing machine consists of separate pumping unit and loading unit. Detailed descriptions of both the devices are narrated below.

Loading Unit:

  1. The upper platen has got a self aligning action and is attached to a rigid cross head plate.
  2. The lower platen rests on the jack ram and is positioned with the help of a centering pin.
  3. Loading is accomplished by upward movement of lower platen.
  4. A dust cover is provided on the jack to prevent any dust from going into the cylinder.
  5. A spacer with a centering locating pin is provided to test small specimens.
  6. The lower and upper platens of the machine are hardened ground and polished.

Pumping Unit:

  1. The pumping unit is a separate unit connected to the jack by means of a high pressure hose pipe.
  2. A junction box is suitably fixed to connect the motor to the mains through a push button starter.
  3. Calibrated against N.P.L. Tested Master Gauge or Proving Ring.
  4. A max red pointer is provided to facilitate taking readings after failure of the specimen.
  5. The pressure gauge is fixed at an Angle for easy readability.

Scope of supply:

  1. High strength rigid structure (Loading Frame)
  2. Pumping unit (Oil source cabinet)
  3. Pressure gauge
  4. Pair of compression platens
  5. High pressure hose pipe

Note:

  1. We strongly recommend using a servo voltage stabilizer to protect the Compression Testing Machine from overvoltage. The machine incorporates sensitive electronic components. Operating it without a stabilizer may cause serious damage or breakdown, which will not be covered under warranty.”